C Style Flex-Flex Couplings
The C Type coupling includes two flex hubs, a single sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Form coupling consist of 1 flex hub, a single rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Characteristics
Simple and inexpensive variety of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in spot
Out there as vertical and horizontal couplings
Wide assortment of particular variations which include full-flex, flex-rigid mill motor
Regular configurations can be found from the shelf
Ordering Data
Application: Driver and Driven.
Sort and dimension of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance concerning shaft ends (BSE).
Shaft sizes.
C and CFR Form Couplings
Ordering Information
Puller Holes are normal on sizes four by twelve.
Puller Holes can be found for sizes 7/8 by means of 3.five at an extra charge.
The BSE (distance Amongst Shaft Ends) may well vary in between G and G1.
Interference bores with no set screws are common unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Segment.
Greater sizes are available, please seek advice from Technical Assistance.