Electrical power UNITS FOR LIFT TABLE

Power UNITS FOR LIFT TABLE one
General Description
This power unit is developed exclusively for that small lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become widely employed during the industry of logistic gadgets for example minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed through the solenoid valve together with the speed managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Standard Description
This electrical power unit is designed solely for that medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as the speed managed by the adjustable needle valve. When the lift rises to a substantial positoin, but the energy supply is cut, the decreasing motion is controlled from the guide override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This power unit is developed exclusively for that significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve as well as the pace managed by a strain compensated flow control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is intended exclusively to the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve as well as the speed controlled by the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is lower, the lowering motion is controlled by the manual override function.
Specific Notes
1. This electrical power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all of the hydraulic components concerned just before set up of the energy unit.
3. Viscosity of the oil shoud be 15~46 cst,which really should also be clean and free of charge of impurities.N46 hydraulic oil is encouraged.
4. Oil altering is needed following the initial 100 operation hrs,afterwards as soon as each 3000 hours.
five. The energy unit proven is made to be mounted vertically.